binary editor use datalogging without saving data

The DT5 datalogging code automatically sets the ECU communications to 38,400 baud, 8 bits, 1 stop bit, no parity, no flow control.īurn the.

Since I am running a JDM P30, I need to select the options tab, uncheck the Disable Knock Sensor box, and check the Disable ELD, Disable PA Sensor and Disable Injector Test boxes. Under Plugin, Enhancements, select 'Quick Datalogger +RTP' to add in the DT5 datalogger code. Under Plugins, Enhancements, select 'Remove Checksum Routine' to remove the checksum. bin you want to use (I used a stock P30-203). This replaces the DT5 code that gets put into the PROM by CROME Beta 1.1.o w/ BoostTools+. Click on 'Install New Plugin' and point to the directory you put quickDLRTP.js into, and finish adding it into Crome. Go into Crome plugin manager, select the built-in quickDLRTP.js entry, and click on delete to get rid of it. Download and unzip John Cui's second quickDLRTP.js plugin file (post is dated: Mon 1:24 pm, not the one in the first post). Īfter you have installed CROME, go to the “Sticky: Quick Datalogger” topic in the CROME Forum. I will ping him to resolve this.įor my ROM Editor, I used “CROME Beta 1.1.0 w/ BoostTools+”, downloaded from the “Sticky: RELEASE: CROME Beta 1.1.0 w/ BoostTools+” topic in the CROME Forum, post dated: Sun 5:51 am. As of 1/2/05, this is backwards from Nicolas Mailloux's document on. Ensure CN2 Pin 4 has connectivity to IC19 Pin 6 (surface mount), this must be Tx Data. Ensure CN2 Pin 3 has connectivity to any Vcc pin of any IC, I used Pin 28 of the PROM socket. Ensure CN2 Pin 2 has connectivity to the 66207 processor Pin 42 (surface mount) or Pin 39 (DIP), Rx Data. Ensure CN2 Pin 1 has connectivity to ground. Ensure there are no solder bridges between any of the CN2 pads. This guidline is based on the USBMOD3 datalogging circuit I integrated into my JDM P30-901 ECU (converted to manual).īefore you start, use an ohmmeter to ensure you have good solder joints and connectors on the TTL-level asynchronous serial port of the ECU. The following is a guideline for how to debug the datalogging circuit you have added to your ECU. Thanks to ltdannear for lots of help in getting this to work.

Binary editor use datalogging without saving data